Todas las categorías

.

Todas las categorías

.

Scorpion A-6528 PNP Combo (standard)

Equivalente a un 60-76cc

999,00 €
Impuestos incluidos
Cantidad:

Size Chart
x
Size Chart

Measuring Tips to Assure The Best Fit

  • Measure your back size – wrap the measuring tape snugly around your ribcage, just under your bust line 1, keeping it horizontal. This will give you your band size.
  • Then measure around the fullest part of your bust 2 , again keeping the tape horizontal.
  • To determine the size of pants, measure the girth of the waist 3 and hips 4
  • The following charts will help you match the designer’s size scheme for this product (indicated in the dropdown) to your usual size

size guide visible to all products

UKUSAEUBUSTWaistHips
XS 8 4 34 31/32 23/24 33/34
S 10 6 36 33/34 25/26 35/36
M 12 8 38 35/36 27/28 37/38
L 12 8 38 35/36 27/28 37/38
XL 10 6 36 33/34 25/26 35/36

This specific A-6528 PNP Combo (12s), is designed for 12s powered 85"-95" Acrobatic Airplanes, or other Sport / UAV airplanes requiring up to 6000w of power. This motor is equivalent to a 60cc/76cc gas engine. We call it 60/76cc because with a 23" prop it is very equivalent to a 60cc gas engine and pulls less amps and therefore could run smaller batteries for lighter overall model weight. Or with a 24" prop it pulls as hard as a 76cc gas engine making over 18.18kg (40lbs) of thrust, but with more amps thus requiring a larger (heavier) battery.

This PNP combo comes with a Scorpion A-6528-200kv motor with pre mounted and 2 tone anodized A-Series Cross Mount (50-70cc), and our sturdy A-Series Standoff Set (30-70cc), which matches perfectly the bolt hole spacing, and length of an equivalently size gas engine + common gas engine standoff. This was designed to fit under the cowl of many standard 60cc-76cc airfames and has enough adjustment shims to fine tune the spacing to your specific airframe. Paired with a pre programmed Tribunus II+ 12-200A ESC, This PNP combo is ready to easily bolt on, and give you the power you need, with the efficiency you want

Recommended Prop Selection :

23x10E = Efficiency / 60cc performance

24x10E = Optimal / 70cc-76cc performance

24x12E / 25x8E = High Alt

 

Acrobatic Weight Range -: 8.18kg - 12.7kg (18.0lbs - 28.0lbs)

Sport / UAV (single engine) Weight Range : - 12.7kg - 36kg (28.0lbs -80lbs)

 

Recommended (Acrobatic) Battery Size - : 12s (44.4v) 5000-6000mah Lipo

Recommended (sport / UAV) Battery Size - : 12s (44.4v) 8000-32,000mah Lipo

 

Specifications

Total Power System Weight (Motor+ESC+Cross Mount+standoffs) 1613g (56.90 oz)

 
MOTOR SPECIFICATIONS :
Motor Kv 200 RPM / Volt
Weight (including cross mount + Prop mount accessories) 1115g (39.33 oz)
Motor Body Dimensions 78.5 mm x 67.8mm+20mm prop spacer (3.09" x 2.67"+0.79")
External Shaft Diameter 10mm
Continuous Current 95A
Continuous Power 4218 Watts
Peak Current* 135A
Peak Power* 6000 Watts
Max Rated Lipo Cell** 12s
Stator Arms 12
Magnet Poles 14

 
ESC SPECIFICATIONS :
Max Continuous Current 200 Amps
Peak Current 250Amps
Operating Voltage Range 14-61 Volts
BEC Output voltage***: OFF/5.1/6.1/7.1/8.1
Max Continuous BEC Output 10 Amps @ 8.1 V
Peak BEC Output 30 Amps/1s @ 8.1 V
Size 86.7 x 45 x 27.6 mm (3.41 x 1.77 x 1.08 in)
Weight (Without Connectors) 224g (7.9 oz)
Drive frequency 8kHz - 32kHz
Cable gauge 10 AWG

Included in the Box

1 x Scorpion A-6528 BLDC Motor
1 x A-65 Cross Mount (50cc-76cc) (Mounted)
1 x A-Series Standoff Set (30cc-76cc) (Mounted)
1 x Tribunus II+ 14-200A ESC
2 x Scorpion 550mm ESC/ BEC Cables
3 x Scorpion Stickers
2 x M10 Nuts

*Our ratings are classified as TRUTHFUL. Continuous Current / Power correlates to actual sustainable power levels. Peak Power is for intermittent full throttle usage ranging from 5 - 60 seconds depending on use case and cooling*
**Higher Cell Count possible with smaller prop usage**
***In this PNP combo, the BEC has been switched off in programming. If using high QTY of high torque / power hungry servos, we advise to use a external Lipo Battery to power your RX. BEC is protected against back voltage, so RX lipo can be plugged in line, without damaging BEC. If user desires, BEC may be switched back on in programming. ***
A_6528_PNP_12

Referencias específicas

Productos Similares