Matrix 1.8m con tren

No hay suficientes productos en stock

2.600,00 €

Impuestos incluidos

Cantidad:

Size Chart

Measuring Tips to Assure The Best Fit

Measure your back size â€“ wrap the measuring tape snugly around your ribcage, just under your bust line 1, keeping it horizontal. This will give you your band size.
Then measure around the fullest part of your bust 2 , again keeping the tape horizontal.
To determine the size of pants, measure the girth of the waist 3 and hips 4
The following charts will help you match the designerâ€™s size scheme for this product (indicated in the dropdown) to your usual size

size guide visible to all products

	UK	USA	EU	BUST	Waist	Hips
XS	8	4	34	31/32	23/24	33/34
S	10	6	36	33/34	25/26	35/36
M	12	8	38	35/36	27/28	37/38
L	12	8	38	35/36	27/28	37/38
XL	10	6	36	33/34	25/26	35/36

Debido a su volumen este modelo tendrá unos gastos de envio de 60€ y será enviado por CBL (2 o 3dias)
Tambien estaria disponible la opcion de recogerlo en tienda, no tendria gastos de envio.

SPECIFICATIONS:

Model:	Matrix 1.8
Wingspan:	68.5″ (1,740mm)
Length:	72.6″ (1,844mm)
Wing area:	–
Weight:	17.5lbs (7.94kg) with 10kg turbine and fuel bag

FEATURES:

Extremely lightweight full composite construction especially designed for outstanding sport flight with 3D performance
Painted outside the mold so no seam lines
Ultra light weight landing gear, the 1.8m predator sport jet landing gear can use to the Matrix too.
Specially designed easy access to turbine for speedy installation
Field setup can be done in seconds, thanks to the quick releases on the wings without the need for any tools.
the single elevator clamp from the top, only a few turns to tight/loose the bolt then you can install/take out the stabilizer.
Removable wing and elevator for easy transport
The equipment installation board make the electronic items with very clear installation. Most of the wire can be hidened.
pre-install tube for the stab/rudder extension wire, easy to install.

INCLUDED HARDWARE:

Complete air frame (including carbon wing-tubes and preinstalled and painted fiberglass control horns)
Pilot-RC electric retracts and electric brakes specific for this model
Servo extension leads
Normal tail pipe
2000ml fuel tank (optional upgrade to fuel bag)
250ml UAT tank
Pre-prepared pushrods with ball links
Servo connector brackets

REQUIRED HARDWARE:

Turbine size:

060-100N

Servos necesarios: Total x8 medium servo (size: 35x15x30mm), the flaps and rudder can install the standard servo as well.
x2 for flaps (minimum 16kg)
x1 for rudder (minimum 16kg)
x2 for ailerons (minimum 16kg)
x2 for elevators (minimum 16kg)
x1 for steering (minimum 10kg)

Also requires all the usual accessories such as transmitter, receiver, batteries, powerbox and possibly other small accessories.